Discovery 1 and 2 Baja Design DOT LP6 Kit

Screws for plastic (#8 size)

Use all the remaining screws to install the lap to the bezel.

Keep all the screws loose at first, tighten down once all screws are threaded in (not too tight, it's plastic!)

Now you can tighten down the bolts on the sides of the lamp.

Connect the custom harness to the lamp and connect the H4 connector to your vehicle.

For the position light, you can click the spade connector inside the vehicle's position light connector (red side).

Push the headlight clip sockets into the adjuster studs and click them into place.

All done!

Make sure to perform an alignment of the headlights before first use!