Discovery 1 and 2 Rear Door Card

Pull the door handle to reveal a philips screw. Remove this screw. 

Remove the door handle trim piece. 

Remove these 6 screws and remove the speaker grille. 

Remove these 4 screws

Remove these 8 screws

Unplug the subwoofer and remove it.

Use a trim tool to pry away the door panel. It is held in by plastic clips 

Breaking some of these clips is almost inevitable. Pull them out with pliers. 

Remove this screw. We will use this as a mounting location too.

NO rivet nut is needed in this location. Do not drill this hole

Remove this door handle mount, if you have it. 

Drill the mounting holes with a 9mm drill bit (provided). 

Assemble your rivet nut setter with an M6 mandrel. Check your tool’s instructions for correctly setting the stroke length. So you are sure to apply the correct pressure.

Install the rivet nuts.

Examine the panel. Cut out the tabs for the door handle cut-out you need. One is meant for Discovery 2, one is for Discovery 1. Remove the cut-out for the one that matches your vehicle

If desired, you can open the subwoofer hole 

We do provide a storage cubby for this space here! 

The square holes are specific to the D1 only. The hexagonal holes are for the D2 only. The rest of the holes are common to both. 

Hang the panel using the bolts and you are done!